Model No : SQR-012

Spintly QR reader with it’s elegant design provides seamless user experience that allows QR based access and also allows users to unlock doors with their smartphones and cards.  
 

1. Product Features and Specifications

2. Mechanical Dimensions   
 

3. Mounting Instructions 

Step 1. The below image show reader, QR module ready to be mounted on pole

Step 2. Assemble the QR module and reader in the top pole housing with adhesive tape 

Step 3. Once the devices are assembled in top housing, pass the pigtail through the opening in the pole as shown in the image below

Step 4. Place the top pole housing on the bottom one as shown in the image below

 Step 5. Close the pole with the help of screws as shown in the image below

4. Wiring Instructions

4.1. Pigtail color code

QR reader is equipped with a 8 core pigtail required during the connection process. The table below describes the signal names along with their corresponding color code.

The reader supports various modes of configuration. The connection of wires will differ based on the selected configuration. To ensure proper setup and functionality, refer to the configurations listed below.

4.2. Configuration 1 : Standalone Spintly Reader (Entry Only)

• Short VIN wire to COMMON wire of Entry Reader
• Connect the locking mechanism (Strike lock or Magnetic lock) to NC (in case of mag lock) wire of Entry Reader
• The sensor inputs,
  • Door Sensor - Connect to the Entry reader
  • REX - Connect to the Entry reader

4.3. Configuration 2 : Spintly Entry + Exit reader
 

• In this mode, both the entry and exit Spintly readers will share the same power lines. Connect together the VIN wires of both the readers. Similarly, for GND wires (ground).
• Short VIN wire to COMMON wire of Entry Reader
• Short NC (in case of mag lock) wire of Entry Reader to COMMON wire of Exit Reader
• Connect the locking mechanism to NC (in case of mag lock) wire of Exit Reader
• The sensor inputs,
  • Door Sensor - To enable DOTL, please connect the door sensor to the Entry Reader
  • Door break-in feature is not available under this configuration.