Model No : SHL-021

Spintly HALO - the fingerprint access control reader is designed for the highest standards of security and reliability. It offers seamless door unlocking using fingerprints, smartphones, or NFC cards, ensuring a reliable and enhanced user experience.
 

1. Product Features and Specifications

2. Mechanical Dimensions 
 

3. Mounting Instructions 

Step 1. Pre-drill the mounting locations using Drill Template provided in the box.
Then mount the unit on the wall with the help of wall plugs (3 qty) and mounting screws (3 qty) as shown below. 

Step 2. Strip and connect the wires as per the pigtail color code and connection diagram. Refer Fig 4.1.1 under Wiring Instructions.

Step 3. Snap in the front face plate as shown in the image below

4. Wiring Instructions

4.1. Pigtail color code

HALO reader is equipped with a 10 core pigtail required during the wiring process. The table below describes the signal names along with their corresponding color code.

The reader supports various modes of configuration. The connection of wires will differ based on the selected configuration. To ensure proper setup and functionality, refer to the configurations listed below.

4.2. Configuration 1 : Standalone Spintly Reader (Entry only)

4.3. Configuration 2 : Spintly Entry with Exit reader

• In this mode, both the entry and exit Spintly readers will share the same power lines. Connect together the VIN wires of both the readers. Similarly, for GND wires (ground).
• Short VIN wire to COMMON wire of Entry Reader
• Short NC (in case of mag lock) wire of Entry Reader to COMMON wire of Exit Reader
• Connect the locking mechanism to NC (in case of mag lock) wire of Exit Reader
• The sensor inputs:
  • Door Sensor - To enable DOTL, please connect the door sensor to the Entry Reader (as shown in above Fig 4.3.1)
  • Door break-in feature is not available under this configuration.

4.4 Configuration 3 : Spintly Reader with Wiegand Controller 

• Below mentioned 5 wires should be connected from Reader to the respective terminal of Wiegand controller 
  • Power wires -- VIN and GND
  • Communication wires -- DATA0 (D0), DATA1 (D1), and GLED (refer the color code shown in above table) to the respective terminals of Wiegand controller.
• Connect the locking mechanism and sensor inputs (Door sensor and REX) to controller